BMW K 1100 LT/RS - Manual (Page 275)

34.17
Removing and installing pressure
modulator
e
Caution:
Work on the ABS unit is only to be carried out by an
authorised BMW workshop.
[ABS I] Removing and installing front
or rear pressure modulator
• Remove the fuel tank.
• Separate plug connector (1) (blue) for the pres
sure modulator.
• Clean the hydraulic pump assembly and the
brake lines.
• Detach brake lines (2/3) at the pressure modula-
tor and seal/cover them.
e
Caution:
Escaping brake fluid will damage painted surfaces.
• Detach the pressure modulator at silentbloc
mount (4) and at the holder.
• Note earth (ground) wire (6).
• Install in the reverse order of work.
• Restore the correct brake fluide level and bleed
the brake system.
X
Tightening torques:
Pressure modulator to holder ....................... 17 Nm
Brake line ..................................................... 18 Nm
LT340130
1
2
3
4
5
6