BMW K 1100 LT/RS - Manual (Page 246)

33.10
Installing drive bevel gear
• Drive sealing ring (2) into threaded rim (3) with
the aid of drift, BMW No. 33 1 760, and retainer,
BMW No. 00 5 550.
• Heat housing to 120 °C.
• Fit drive bevel gear complete with spacer (1).
• Fit outer race (6).
• Coat threaded ring (3) with Hylomar SQ 32 M,
thread turns must be free of grease.
• Firmly tighten threaded ring with pin wrench,
BMW No. 33 1 700.
• Fit thrust ring (4).
L
Note:
Ensure the sealing lip of the shaft sealing ring is fit-
ted correctly at the thrust ring.
• Coat hexagon nut (5) with Loctite 270, thread
turns free of grease and firmly tighten using
36 mm (1.4173 in) insert, BMW No. 33 1 720.
e
Caution:
Nut must not damage shaft sealing ring!
X
Tightening torquse:
Threaded ring
(clean thread + Hylomar SQ 32M) .............. 118 Nm
Nut for drive bevel gear
(clean thread + Loctide 273)....................... 200 Nm
LT330080
120°C
1
6
2 3 4 5
00 5 500
LT330090
33 1 760
2
3