BMW K 1100 LT/RS - Manual (Page 278)

34.20
[ABS II] Removing and installing
relay and relay base
[ABS II] Removing relay
e
Caution:
Switch off the ignition and disconnect and insulate
the earth (ground) lead.
• Remove cover (1) from ABS control unit, press
the catch in with a screwdriver and pull the cover
off upwards.
• Cover (1) must be scrapped.
• Disconnect wires (2) and scrap the retaining
nuts.
e
Caution:
Do not tilt the cables or the insulation may be dam-
aged.
• Pull off the 2-pin plug.
• Take out relay base (4).
• Loosen the screws at the relay base by app. 2
turns with a Torx T20 screwdriver.
• Pull the relay off upwards.
[ABS II] Installing relay
• Insert ABS relay with FAG logo in the direction of
the retaining hook.
• Tighten the screws at the relay base.
• Push the relay base into the relay housing, at the
same time pressing both engine wires into the
left relay housing cable guide (red at bottom,
black at top).
• Attach black cable to left threaded pin (M5) with
the crimp facing to the rear.
e
Caution:
Do not tilt the cable or the insulation may be dam-
aged.
• Push the 2-pin plug fully on in the correct posi-
tion and press the two wires into the centre
(smaller) cable guides.
• Attach both connecting lead/wiring harness
plugs to the threaded pins with the crimp facing
forwards.
• Press both leads into the remaining cable
guides.
• Tighten the nuts.
e
Caution:
Always use new self-locking nuts.
LT340270
1
3 2 4