Re-assembling motorcycle – BMW K 1100 LT/RS User Manual

Page 202

Advertising
background image

23.28

Re-assembling motorcycle

Install battery.

Intall Motronic control unit.

[ABS II] Install ABS unit.

Install battery.

Intall Motronic control unit.

[ABS I] Install control unit.

Install swinging arm.

Install footrest plates.

[ABS I] Install pressure modulators.

Install rear wheel drive.

Install suspension strut.

Install rear wheel.

Install brake caliper

L

Note:

Check ABS sensor gap.

Install exhaust system.

Install rear mudguard.

Install side section of fairing.

X

Tightening torques:

Fixed swinging arm bearing at geabox ........... 8 Nm
Fixed swinging arm bearing journal,
free bearing ................................................. 7.5 Nm
Locknut, free bearing ................................... 41 Nm
Bearing pin of fixed bearing ....................... 150 Nm
(clean thread + Loctite 2701)
Bearing pin of loose bearing .......................... 7 Nm
(clean thread + Loctite 2701 applied to entire
length of thread on loose bearing pin)
Locknut ...................................................... 105 Nm
Suspension strut to frame/rear wheel drive .. 51 Nm
Rear wheel studs ....................................... 105 Nm
Exhaust pipes to cylinder head .................... 21 Nm
Exhaust system to holder/footrest plate ......... 9 Nm
Front silencer (muffler) to gearbox ................ 12 Nm
Footrest plate to gearbox ............................. 15 Nm

Advertising