BMW K 1100 LT/RS - Manual (Page 282)

34.24
Removing and installing rear brake
disc
• Remove brake caliper.
• Remove rear wheel.
• Remove brake disc.
L
Note:
Mark installation position of the brake disc so that
the vertical runout of the pulse wheel is not
changed.
• Install in the reverse order of removal.
L
Note:
Screw in retaining screws with Loctite 270.
Check ABS sensor spacing, if necessary adjust with
spacer plates.
X
Tightening torque:
Brake disc carrier ......................................... 21 Nm
e
Caution:
ABS - The vertical runout must be determined if the
brake disc and therefore also the pulse wheel are re-
placed.
LT340150