BMW K 1100 LT/RS - Manual (Page 52)

11.18
• Place the cup spring in position.
• Insert the freewheel (oiled with engine oil) into the
outer race.
• Install the outer race (with clamp block facing
cover plate); the cup spring must snap into the
outer race.
• Place the cover plate in position.
X
Tightening torque:
Retaining screws.......................................... 10 Nm
• Push the freewheel gear on to the layshaft while
turning it clockwise.
• Push the thrust washer and O-ring on to the lay-
shaft.
Removing and installing layshaft nee-
dle roller bearing
Removing bearing
• Heat the bearing seat to 100 °C.
• Pull out the bearing with counter-support,
BMW No. 00 8 570, and internal puller 21/3,
BMW No. 00 8 574.
• If the bearing is defective and cannot be pulled
out, carefully cut through the needle roller sleeve
with a grinder.
Installing bearing
• Heat the bearing seat to 120 °C.
• Centre the bearing and drive it in with a
21 mm (0.82 in) drift with a pin of smaller
diameter (15.95 mm/0.628 in).
LT110190