BMW K 1100 LT/RS - Manual (Page 342)

61.6
[ABS I] Removing and installing
control unit
e
Caution:
Switch off ignition, disconnect and insulate earth
(ground) lead!
• Switch off ignition, disconnect and insulate
ground lead!
• Open dualseat.
• Press catch (1) for multi-pin plug and detach
plug.
• Loosen screws (2) at left and right and remove
housing (3) together with control unit.
• Remove ABS control unit (4) from housing (5).
• Install in the reverse order of removal.
L
Note:
Ensure that lug (6) on housing (3) is fitted correctly in
the battery support bracket.
[ABS II] Removing and installing
control unit
L
Note:
[ABS II] The control unit is on the pressure modula-
tor.
For removal, see Group 34 “Removing and installing
ABS unit”.
LT610020
4
3
1
5
2
6