BMW K 1100 LT/RS - Manual (Page 327)

46.25
Assembling side stand
L
Note:
The securing screw of the side support is micro-en-
capsulated and cannot be reused. Clean thread and
holes. Coat screws with Loctite 243 before insert-
ing.
• Fit securing screw (6) with Loctite 243.
• Fit leg spring (1) as illustrated.
• Install operating hook (2) and bracket (3), note in-
stallation position (arrow).
e
Caution:
Do not grease operating hook and bracket,
increased dirt accumulation!
• Attach tension springs (4).
• Prior to installation, check condition of switch,
contact spring must not be bent.
• In no-load condition, there must be an air gap
(clearance) between the contact spring (1) and
contact point on the switch.
• Secure switch with 2 O-rings (2) on the retaining
screws for the bearing block.
• Install stand with side stand.
X
Tightening torque:
Side stand to bearing block ......................... 41 Nm
LT460350
2
4
3
1
LT460360
2
1