BMW K 1100 LT/RS - Manual (Page 313)

46.11
Removing lever
• Remove actuator motor.
• Remove plate.
• Detach spring.
• Release securing element (3) of guide rod (4),
while holding with pin (5).
• Pull guide rod out of sliding bushing, note
O-rings (6).
• Remove retainer (7) and press out shaft (8).
• Install in the reverse order of removal.
L
Note:
The retaining screws are micro-encapsulated and
therefore cannot be re-used. Clean the threads and
the holes. Coat screws with Loctite 243 before in-
serting.
Spray guide rod with silicone spray.
Removing guide bush in lever
• Remove lever.
• Loosen locknut (1), unscrew pressure screw (2).
L
Note:
Installation:
Only tighten pressure screw such that the guide
bush can still be moved easily, then lock with hexa-
gon nut.
X
Tightening torque:
Locknut .......................................................... 7 Nm
Removing sliding piece
• Remove actuator motor.
• Remove plate.
• Remove lever.
• Release securing element (3) for sliding piece (4)
on the plate.
• Remove retaining bracket (5) for tubes.
• Remove sliding piece completely out of tube.
LT460100
3
4
8
3
5
6
7
LT460110
1
2
LT460120
3
5
4