BMW K 1100 LT/RS - Manual (Page 199)

23.25
Installing transmission (gearbox)
• Clutch thrust bearing must be removed.
• Check centre position of driving disk.
• Coat spline of input shaft, for example with
Optimoly MP 3.
• Screw guide pins, BMW No. 23 1 820, in the
holes with centring sleeve in the intermediate
flange.
• Screw in long pin on right-hand side.
• Fit slip sleeve, BMW No. 23 1 800, on control
rod.
• Fit control rod from front through the input shaft.
• Place transmission on guide pins (oiled) and
carefully slide into position.
X
Tightening torque:
Transmission to intermediate flange ............. 16 Nm
• Install clutch thrust bearing.
23 1 820
LT230470
23 1 820
LT230530
23 1 800