BMW K 1100 LT/RS - Manual (Page 26)

00.18
Checking clutch clearance and
adjusting if necessary
Inspections I, III
• Detach clutch cable at clutch release lever (1).
• Slightly push back rubber sleeve (2).
• With the aid of setting gauge,
BMW No. 21 3 500,set dimension “b” with ad-
justing screw at clutch hand lever.
Dimension “ B ” ..... 75 ± 1 mm (2.952 ± 0.03937 in)
• Reattach clutch cable at clutch release lever.
• Using box spanner, BMW No. 21 3 610,release
locknut (6) of adjusting screw (7) at clutch re-
lease lever.
• Unscrew adjusting screw by one to two turns,
then screw in until pressure can be felt.
• Lock adjusting screw with locknut.
• Set dimension “A” with adjusting screw at clutch
hand lever.
• Lock adjusting screw (5) with knurled nut (3).
Dimension “A” ........ 4 ± 0.5 mm (0.157 ± 0.0197 in)
e
Caution:
Adjust to take up wear only at the adjusting screw
on the clutch release lever.
Reading out Motronic defect code
memory
Inspections II, III
• Carry out this job only on motorcycles with cata-
lytic converter.
L
Note:
To read out Motronic defect code memory, see the
booklet entitled:
“BMW Diagnosis, Motronic 2.1 with oxygen-sensor
control” (order No. 01 70 9 798 970).
LT000160
2
1
B
LT000170
7
6
LT000180
5
4
3
A