BMW K 1100 LT/RS - Manual (Page 285)

34.27
Removing and installing rear master
brake cylinder
• Drain brake system.
e
Caution:
Ensure brake fluid does not come in contact with
painted parts of the vehicle; brake fluid destroys the
paintwork.
• Release brake line (1) at master brake
cylinder (2).
• Remove footrest plate.
• Release master brake cylinder (2).
• Note spacer sleeve (3); spring is under pressure.
• Open clip (4) on the supply line, detach line.
• Install in the reverse order of removal.
e
Caution:
Carefully bleed brake system.
X
Tightening torques:
Master brake cylinder..................................... 9 Nm
Brake line to master brake cylinder .............. 18 Nm
LT340180
1 2
3
4
LT340190
3