Abs ii] bleeding pressure modulator, Bleeding the handlebar fitting, Bleeding rear brake – BMW K 1100 LT/RS User Manual

Page 274: Bleeding brake caliper

Advertising
background image

34.16

[ABS II] Bleeding pressure modulator

•

Remove the left battery cover.

•

Connect a vessel to the brake caliper bleed
screws to trap escaping brake fluid, then open
the bleed screw by half a turn.

•

Maintain pressue at the handbrake lever and
open the bleed screw, at the same time pulling
the hand brake lever in firmly.

e

Caution:

Do not release the handbrake lever until the bleed
screw has been closed.

•

Allow the brake fluid to emerge from both brake
calipers until it is clear and free from bubbles.

•

Close the bleed screw while keeping the hand
brake lever pulled in.

Bleeding the handlebar fitting

•

Remove combined switch (1) from the right han-
dlebar fitting.

•

Remove clamping screw from handlebar fitting.

•

Turn the brake flulid reservoir up round the han-
dle bar (arrow) until the air escapes from the
brake line.

•

Turn the reservoir back down.

•

Tighten the clamping screw on the handlebar fit
ting.

L

Note:

When adding brake fluid, note the thickness of the
brake pads. Add brake fluid up to the -MAX“ mark if
the pads are new.

•

Add brake fluide.

L

Note:

When checking front brake fluid level, the brake fluid
reservoir must always be in a horizontal posi tion.

•

Replace the diaphragm and reservoir cover in po
sition.

•

Tighten the retaining screws without using force.

•

Check brake operation.

•

Install the combined switch.

Bleeding rear brake

Bleeding brake caliper

•

The rear brake caliper does not have to be remo
ved, nor the pistions pressed back.

•

The remaining procedure is the same as when
bleeding the front brake circuit.

X

Tightening torque:

Brake caliper to rear wheel drive .................. 40 Nm

[ABS II] Bleeding pressure modulator

•

Follow the same procedure as when bleeding the
front brake circuit.

L

Note:

When adding brake fluid, note brake pad thickness.
Add brake fluid up to the „MAX“ mark with new pads.

•

Add brake fluid.

•

Replace the diaphragm and reservoir cover in
position.

•

Check that the brake is operating correctly.

LT340310

1

LT340260

MAX

MIN

Advertising