BMW K 1100 LT/RS - Manual (Page 189)

23.15
Disassembling and assembling input
shaft
Disassembling input shaft
• Clamp spline end of input shaft in vice with jaw
guard.
• Remove retaining ring (1).
• Using universal puller, BMW No. 00 7 500, and
pressure tool (arrow), remove spur gear (3) to-
gether with taper roller bearing (2).
• Also remove second taper roller bearing.
Assembling input shaft
• Fit washer (6), coil spring (5), thrust piece (4) and
spur gear (3) on input shaft.
• Using universal puller, tension spur gear against
coil spring until the 2nd groove (arrow) can be
seen ahead of the spur gear.
• Heat taper roller bearing to 100 °C and fit in po-
sition.
• Fit retaining ring (1) in front of the taper roller
bearing.
LT230170
5
6
4
3
2
1
00 7 500
LT230180
00 7 500
LT230190