BMW K 1100 LT/RS - Manual (Page 80)

11.46
Installing intermediate flange
Installing freewheel
• Insert the freewheel into the crankcase with the
helical-cut gearwheel leading.
• Oil the needle roller bearing well.
Installing countershaft
• Insert countershaft (1) into the crankcase with
the small gearwheel facing downwards.
• Insert spring (2) with the larger external
diameter (arrow) projecting upwards and located
behind the freewheel gear.
Installing intermediate flange
• Apply a thin coat of 3-Bond 1209 to the sealing
faces, which must be free from oil and grease.
• Attach the intermediate flange (with all collets in
position).
• Tighten screws with Torx insert,
BMW No. 00 2 600.
X
Tightening torque:
Intermediate flange......................................... 9 Nm
L
Note:
Note rubber filler in the starter motor area.
Installing driver
• Clean tapped hole and screw (must be free from
grease).
• Push driver on to layshaft.
• Secure retaining screw with Loctite 273 FL.
X
Tightening torque:
Driver ........................................................... 33 Nm
Installing alternator
• Install the alternator with the damping rubber.
X
Tightening torque:
Alternator ..................................................... 22 Nm
1
2
LT110690