BMW K 1100 LT/RS - Manual (Page 198)

23.24
Installing transmission cover
• Knock out cap (arrow) from the inside using a
drift.
• Heat up transmission cover to 100°C.
• Parting surface at housing and cover must be
clean and free of grease.
• Thinly coat one of the two parting surfaces with
Loctite 574 or with Three-Bond 1209.
• With the aid of a drift or screwdriver, press back
locking lever in direction shown by arrow.
• Carefully fit cover on the housing.
• Screw in screws holding transmission cover and
firmly tighten.
X
Tightening torque:
Retaining screws for cover ............................. 9 Nm
• Thinly coat end cap (arrow) with
Three-Bond 1209 and knock in with drift by
8 mm (0.31496 in).
• Fit idle lock (ball and spring) in idle position.
• Screw in screw for idle lock coated with
Loctite 243.
X
Tightening torque:
Screw for idle lock ........................................ 13 Nm
LT230420
LT230370
LT230380