BMW K 1100 LT/RS - Manual (Page 163)

21.5
Removing clutch
• Secure lifting gear, BMW No. 00 1 510, to the oil
sump.
• Remove main stand.
• Remove rear mudguard.
• Remove right-hand footrest plate.
• Remove Motronic control unit.
• Remove battery.
• [ABS I] Remove ABS control unit.
• [ABS I] Secure pressure modulators to rear
section of frame.
• [ABS II] Remove ABS unit.
• [ABS I] Remove holder for demodulators.
• Release bottom retaining bolts (1) holding trans-
mission.
• Re-install main stand without switch for electric
side support.
• Remove transmission together with the com-
plete rear wheel drive and rear wheel.
L
Note:
Keep transmission at installation height until the
clutch control rod can be seen completely, since it
can be easily bent.
L
Note:
To remove the ABS unit, see also Group 34, “Re-
moving ABS unit”.
LT210130
00 1 510
LT210140
1