BMW K 1100 LT/RS - Manual (Page 91)

12.5
Removing and installing Hall gener-
ator
• Disconnect ground lead of battery and insulate.
• Remove radiator cowling.
• Remove fuel tank.
• Disconnect Hall generator (1) plug connection.
• Remove cover (2) together with gasket (3).
• Remove base plate (4).
• Remove rotor (5) and setting plate (6).
L
Note:
Mark installation position of setting plate on engine
case, or remove in TDC position.
• Install in the reverse order of removal.
L
Note:
The recess on the engine case and on the base
plate must be aligned flush.
X
Tightening torques:
Base plate ................................................... 3.5 Nm
Cover ............................................................. 9 Nm
LT120010
6
1
5 4 3 2