BMW K 1100 LT/RS - Manual (Page 66)

11.32
Stripping and assembling output shaft
Stripping down output shaft
• Take off needle roller race (1) and circlip (2).
• Pull output shaft (3) out of damper housing (4).
• Drive the output shaft out of the inner section of
the damper (5) with a plastic-faced hammer.
Stripping down tensioning gear
• Clamp the damper housing into a vise with soft
jaws, to take the load off circlip (7).
7
8
9
10
11
6
5
1
2
3
4
LT110450
7
LT110460
• Remove circlip (7) with Seeger circlip pliers.
• Using two-arm puller, BMW No. 00 8 400, and
thrust block, BMW No. 33 1 307, pull off ball
bearing (8).
• Take off spacing ring (9).
• Remove tensioning gear (10) with counter-hold-
er, BMW No. 12 4 600.
• Remove tensioning spring (11).
L
Note:
Inspect all parts for damage or wear.