BMW K 1100 LT/RS - Manual (Page 268)

34.10
Removing and installing front ABS
sensor
• Remove fuel tank.
• Disconnect plug connection (1) of sensor line.
• Remove cover for brake distributor.
• Remove rear section of mudguard.
• Detach cable clips.
• Release sensor (2) with Torx socket,
BMW No. 34 2 500.
• Install in the reverse order of removal.
L
Note:
Carefully install the sensor line (arrow), note position
and number of cable clips and ensure tyre can turn
smoothly.
Check sensor spacing where the gap is largest; if
necessary readjust with spacer plate (3).
Sensor spacing
Up to 1996 MY............................... 0.50 - 0.55 mm
From 1997 MY ............................... 0.45 - 0.55 mm
X
Tightening torque:
Sensor to fork slider tube .............................. 4 Nm
LT340070
1
3
2