BMW K 1100 LT/RS - Manual (Page 184)

23.10
Disassembling/assembling transmis-
sion cover
Removing and installing bearing shell
• Heat bearing cover to 100 °C.
• Remove bearing shell with Kukko support,
BMW No. 00 8 560, and internal extractor 21/5,
BMW No. 00 8 563.
• Fit bearing shell in transmission cover while still
hot.
• Drive bearing shell onto the bottom of its seat
with drift, BMW No. 23 1 700, and handle
BMW No. 00 5 500.
Removing and installing shaft sealing ring on
input shaft
• Drive out shaft sealing ring with drift from the in-
side.
• Fit new sealing ring with drift, BMW No. 23 1 770
and handle, BMW No. 00 5 500.
L
Note:
If the coefficient of friction of the input shaft is to be
checked, do not fit sealing ring until measurement
has been completed.
Removing and installing locking lever
• Release retaining ring (1)
• Lift short arm of spring over contact surface (ar-
row).
• Remove lever and spring.
• Install in the reverse order of removal.
LT230020
100°C
00 8 563
00 8 560
00 5 500
LT230030
23 1 770
23 1 770
LT230040
00 5 500
LT230050
1