BMW K 1100 LT/RS - Manual (Page 325)

46.23
Removing and installing main centre
stand
• [RS] Remove lower section of fairing .
• Raise motorcycle with lifting gear,
BMW No. 00 1 510, under the oil sump until
stand is free to move.
• Disconnect cable clips for side stand line.
• Release retaining screws (1) and detach main
stand together with side stand.
• Install in the reverse order of removal.
L
Note:
The retaining screws are micro-encapsulated and
can therefore not be re-used. Clean thread and
holes. Fit screws with Loctite 243.
Line arrangement for side stand
X
Tightening torque:
Main stand to bearing block ......................... 41 Nm
LT460310
1
00 1 510
LT460320
LT460330