BMW K 1100 LT/RS - Manual (Page 53)

11.19
Removing timing chain cover
Removing the Hall-effect signal transmitter
• Remove cover (1).
• Take off gasket (2).
• Remove Hall-effect signal transmitter (3), noting
the semi-circular shim washers.
L
Note:
Mark the correct installed position of the adjusting
washer on the engine block, or remove it in the TDC
position.
• Remove gate rotor (4) and take off adjusting
washer (5).
Remove the crankshaft cover
• Detach the coolant hose at the water pump and
radiator.
• Remove the cover.
Removing cylinder head cover
• Remove the ignition leads.
• Remove the cylinder head cover.
Removing and installing sealing ring in timing
case cover
• Drive the sealing ring out with a suitable drift.
• Drive the sealing ring in from the inside using
handle, BMW No. 00 0 500, and drift,
BMW No. 11 1 610.
1
2
3
4
5
LT110200
LT110210