BMW K 1100 LT/RS - Manual (Page 270)

34.12
Removing and installing front brake
line
Removing upper brake line
• Drain brake system.
• Remove fuel tank.
• Release brake line (1) at handbrake cylinder.
• Remove cover for brake distributor on mud-
guard.
• Release brake line at the distributor.
• Install in the reverse order of removal.
L
Note:
Secure brake line to handbrake cylinder such that it
does not chafe or kink when the handlebar is turned.
Replace sealing rings of brake lines.
e
Caution:
Ensure brake fluid does not come in contact with
painted parts of the vehicle; brake fluid destroys the
paintwork.
Removing lower brake line
• Remove rear section of mudguard.
• Release brake line at distributor and at the brake
caliper.
• Install in the reverse order of removal.
L
Note:
Replace sealing rings of the brake lines.
• Carefully bleed brake system.
X
Tightening torques:
Brake line to handbrake cylinder .................. 18 Nm
Brake line to distributor ................................ 18 Nm
Brake line to brake caliper............................ 18 Nm
Bleed screw ................................................. 14 Nm
LT340090
1
LT340100