BMW K 1100 LT/RS - Manual (Page 30)

00.22
Installing cylinder head cover
• Screw fitted bolt, BMW No. 11 1 980, (arrow)
into inner hole at the front.
• Press centring pin, BMW No. 11 1 990, with
gripper, BMW No. 00 5 500, into locating hole
under the third camshaft bearing.
• Insert gasket into cylinder head cover.
L
Note:
Begin installation at the crescents (1).
• The marks (arrows) on the cover and gasket
must agree at the front and rear.
• First press in the crescent at the rear (transmis-
sion end).
• Lightly coat the gasket groove and the crescent
areas in the cover with oil to facilitate installation.
• Apply a little 3-bond 1209 in the joint area at the
top and bottom chain case cover - cylinder head
(surfaces free of grease).
• Fit cylinder head cover with gasket over the cen-
tring tools onto the cylinder head.
• Screw in all retaining bolts such that they are still
not under preload.
• Firmly tighten retaining bolts crosswise working
from the inside towards the outside.
• Remove fitted bolt and centring pin, screw in last
retaining bolt and firmly tighten.
X
Tightening torque:
Cylinder head cover to cylinder head ............ 9 Nm
11 1 980
LT000230
11 1990
LT000240