JLG X23J Operator Manual - Manual (Page 100)

BOOM LIFT MODELS X23J
JLG
96 X23JR0620113
and damages or even the death of the operators or people near the working area. It is absolu‑
tely compulsory to work with machine stabilized under the inclination limit admitted by the
manufacturer. The aerial platform is considered stabilized when the inclination is less than 1°
and the tracks are lifted of at least 5 cm from the ground. IT IS ABSOLUTELY FORBIDDEN
TO WORK IN HEIGHT WITH TRACKS NOT COMPLETELY LIFTED FROM THE
GROUND.
Stabilizing the machine with a inclination degree higher than the one admitted may cause
instability of the machine and damages or even the death of the operators or people near
the working area. It is absolutely compulsory to work with machine stabilized under the
inclination limit admitted by the manufacturer.
6.4.13 T
RACK WIDENING
Act as follows to make the variation to the machine track:
•
Operate on buttons 3‑9 to widen/narrow the undercarriage.
NOTE: the track widening operations should be performed with the machine stabilised and
lifted from the ground. If this is not possible, perform the widening operations simultaneou‑
sly with track movement.
Do not open/close the track with the belts at a standstill and resting on the ground.
6.4.14 B ASKET MOVEMENT
Once the machine has been stabilised correctly (check icon position 5) the basket can be
moved.
• It is prohibited to load material of any type into the basket if the machine is not stabi‑
lised and completely closed. To load and unload the basket the icon in position 6 on
the remote control must be displayed. Loading material into the basket when it is lif‑
ted (e.g. from roofs, balconies etc.) causes the machine to tilt exposing the occupants
and the staff on the ground to a probable risk of death.
• It is absolutely forbidden to use the machine to lift loads both in the basket and con‑
nected in other way to the structure; It is prohibited to use the machine to lift loads;
the machine can lift two persons (80 kg each) plus 40 kg of tools or using the jib one
person (80 kg) and 40 kg of tools.
• During machine lowering, in proximity of the upper arms resting on the lower ones, a
potential shearing risk is created, appropriately signalled by stickers; it is the user’s
responsibility to move persons away from this area.