JLG X23J Operator Manual - Manual (Page 65)

61
always in maximum displacement, therefore average traversing speed.
• F AST : engine revs variable depending on the movement selected. Traversing engines in
automatic displacement variation mode, therefore maximum traversing speed.
The three speeds are selected by pressing button 5 in sequence according to a cyclical rou‑
tine. The selected speed is displayed on the screen in position 4 .
BUTTON 6:
Allows access into the auto service menu (ref. paragraph 9 Service menu on remote control).
PULSANTE 7:
It enables to carry out the auto‑stabilization of the machine.
BUTTON 10: (DIESEL VERSION ONLY)
Allows activation of electrode pre‑heat. Pressing the button determines pre‑heating of 10
seconds. In the case of advanced start‑up, pre‑heating ends on start‑up.
BOOM LIFT MODELS X23J
JLG
X23JR0620113