JLG X23J Operator Manual - Manual (Page 169)

165
8.3.1 H
OW AND WHERE TO ATTACH THE PLATFORM
To lift the platform it must be attached to each outrigger using the appropriate fixing rings as
indicated in the photo below.
It is prohibited not to attach all four feet, the machine may not be balanced. Moreover, it is
mandatory to use four distinct ropes, chains or slings; in this way breakage or incorrect
anchorage of a connection device would not implicate dangerous load movements.
8.3.2 W
HAT TO USE TO ATTACH THE PLATFORM
The lifting devices must be in good working order and used according to the specifications
supplied by the Manufacturer. As the weight of the platform is not spread equally over the
four outriggers, the minimum required capacity of the four ropes, chains or slings used must
be: no less than 2000 kg and their length no less than 3 m and all identical.
The width of the slings must not exceed 60 mm, the width of the chains must not exceed 25
mm, the diameter of the ropes must not exceed 25 mm in order not to exert a pressure in an
anomalous direction on the outrigger plate.
The use of ropes, chains or slings with length less than 3 m could cause permanent damage
to the machine outriggers.
BOOM LIFT MODELS X23J
JLG
X23JR0620113
IMPORTANTE IMPORTANT