JLG X23J Operator Manual - Manual (Page 50)

machine works with jib open this load is 120 kg. If working with jib closed, the maximum
accepted load is 200 kg.
The indication of the max load based on the working mode is always displayed on the remo‑
te control.
When the maximum accepted load is reached, an icon appears on the remote control display
along with an acoustic signal and all platform movements are prevented. To restore platform
functioning the excess weight must be removed in order to drop below the maximum weight
accepted. (see paragraph regarding the display visualizations ).
The Constructor recommends that maximum attention is paid to
the state of all safety components and in particular to the system
that makes up the basket load sensor; always check correct func‑
tioning whenever objects are struck with the basket or if jobs are
being carried out that can damage the system (e.g. pruning,
painting etc.).
Before ascending, always make sure that the two lids of the vertical pins are COMPLE‑
TELY fastened into their seat.
3.9 C
ONTROL PROTECTIONS
The remote control is protected against the accidental fall
of objects from above and involuntary activation by the
operator by a protection structure.
Always check integrity before using the machine.
3.10 S
PIRIT LEVEL
The spirit level is positioned on the turret where it can be well
seen from the basket and from the ground. The spirit level must
be used to check that during the platform levelling phase the
maximum accepted inclination limit of 1° is respected. For this
to take place, the air bubble must never go out of the green area.
A second electronic spirit level, contained in the control board,
checks that this condition is effectively satisfied and checks the power supply of the controls
relative to the aerial part.
BOOM LIFT MODELS X23J
JLG
46 X23JR0620113
PERICOLO
ATTENZIONE ATTENTION
DANGER
L ID