JLG X23J Operator Manual User Manual
Page 77
73
6.1.3 D
ANGER DUE TO THE WORK AREA
THE MACHINE CAN ONLY WORK ON COMPACTED GROUND.
Always verify that the slope of the ground in the platform positioning area does not exceed
the stabilization max inclination. During the stabilisation phase, use the spirit level positio‑
ned in proximity of the main controls to check that the maximum inclination of the coupling
with respect to horizontal does not exceed 1°.
Check the route for the presence of persons, holes, overhangs, obstacles, debris and cove‑
rings, which may hide holes.
Before entering any high risk area (refineries, power stations etc.) check accessibility with the
plant safety staff.
6.2 PROCEDURES FOR CORRECT USE
Below find the procedures for use of the platform as declared by the Constructor. Any use
different to that stated below, unless authorised in writing by the Constructor. is prohibited.
6.2.1 S
UMMARY TABLE OF THE SAFETY STANDARDS FOR THE OPERATOR
The summary table is shown below with the general safety standards that must be followed
scrupulously by the operator before starting to use the platform.
Remember that a sticker with this table can be found near to the controls positioned on the
basket where it is well visible from the control position.
•
The use of the platform is reserved only for suitable, previously‑trained staff.
•
All manoeuvres of the extendible structures must be performed from the control posi‑
tion on the basket. The traversing and stabilisation manoeuvres must be carried out after
previously checking that there is complete visibility of the operational area. If the machi‑
ne is controlled from the ground, stay at a minimum distance of 1 metre from the same.
•
The use and maintenance instructions indicated in the USE AND MAINTENANCE
MANUAL, attached to the machine, must be followed scrupulously.
•
Never exceed the maximum capacity accepted indicated in the USE AND MAINTE‑
NANCE MANUAL and on the basket.
•
The operator must wear a helmet and safety the slinging, which are appropriately atta‑
ched to the relevant anchorage points of the basket.
Remember to check the slinging periodically.
The use of the safety belts is compulsory in connection with the local regulatins of every
single State. In those States where the law does not require the use of holding systems,
BOOM LIFT MODELS X23J
JLG
X23JR0620113
IMPORTANTE
IMPORTANT