JLG X23J Operator Manual - Manual (Page 97)

93
BOOM LIFT MODELS X23J
JLG
X23JR0620113
To verify the inclination of the frame there is a spirit level on the machine; when the air bub‑
ble it contains is completely inside the green area (see photo below) the machine is in condi‑
tions in which its use is allowed.
Please note that stabilize the machine on slopes greater than allowable limits (see technical
data of the machine) does not permit correct stabilization and is a serious danger for users.
On each outrigger (see photo below), in proximity of the cylinder attachment to the outrigger
itself, there is an orange light. This light flashes to indicate that the outrigger is resting on the
ground.
Note:
IT IS IMPORTANT THAT WHEN THE MACHINE IS STABILISED THE TRACK IS
ALWAYS
LIFTED
FROM THE GROUND .
After using the manual control of stabilizers, remember to pressurize the stabilizers cylin‑
ders bottoms.
To do this make a cycle of self‑stabilization or lower each stabilizer for a while.
An electronic spirit level inside the electronic control board checks that the machine is posi‑
tioned effectively on the flat with the tolerance admitted and enabling the movements of the
aerial part.
Incorrect machine stabilisation does not allow suitable stability to perform jobs. The Con‑
structor prohibits the use of the machine if it is not stabilised according to that prescribed in
this manual; machine tilting can cause serious injury even death of its occupants and the
staff on the ground.
IMPORTANTE
IMPORTANT