JLG X23J Operator Manual - Manual (Page 15)

11
nical breakdown).
There is a control position usable only for operations of ordinary and extraordinary mainte‑
nance operations, position placed next the machine near the electic components box.
At the back of the protection box of the circuit board an auxiliary connector is placed for the
connection of the optional second remote control (see picture).
To enable this position it is necessary to operate on the key selector placed on the base of the
turret and connect the optional second remote control to the machine.
Before proceeding with the connection read carefully paragraph regarding the use of the
optional second remote control.
This control position is usable only to carry out controls and maintenance on the machine.
Do not use this position to control the machine during normal working operations.
Note: it is absolutely forbidden to move the machine from this position if one ore more
operators are in the basket.
BOOM LIFT MODELS X23J
JLG
X23JR0620113
PHOTO 1 PHOTO 2
P OSITION OF THE OPTIONAL SECOND
REMOTE CONTROL CONNECTOR
OPTIONAL SECOND REMOTE
CONTROL CONNECTOR
ATTENZIONE ATTENTION