JLG X23J Operator Manual - Manual (Page 157)

153
BOOM LIFT MODELS X23J
JLG
X23JR0620113
7.25.3 R EPLACING THE BATTERY THERMIC VERSION
‑ Do not remove cables with the engine running.
‑ Disconnect the battery clamps, always starting from the negative pole (‑).
‑ Re‑connect the electric cables always starting from the positive pole (+).
Replace the battery with one that has the same features, when this no longer accumulates
energy.
See the features table on the battery.
7.25.4 D ISPOSAL OF THE BATTERY
Refer to the attached use and maintenance manual.
7.26 B
ATTERY PACK OPERATING SPECIFICATIONS
The battery pack must be used and handled with care to ensure safe operation and maxi‑
mum machine performance.
The battery pack has a rated voltage of 70 Vdc; any modifications made by unauthorised per‑
sonnel invalidate the warranty and may cause damage to the machine and harm to people
and things.
Only qualified personnel are authorised to handle and access the battery pack.
The battery pack is made up of just one module positioned at the rear of the machine. The
weight of the battery pack is around 120 kg.
In case of problems, only authorized personnel are authorised to access the battery pack and
replace it.
Additional electronic devices may have a negative influence on the correct operation of the
electronic components provided on the machine. For this reason it is absolutely forbidden to
use any devices on the vehicle that do not comply with directive 72/245/EEC and its subse‑
quent amendments (2005/49/EC, 2005/83/EC, 2006/28/EC).
The constructor accepts no liability for any damage due to failure to comply with this war‑
ning.
Opening and handling the battery pack is dangerous. Failure to observe this warning auto‑
matically voids the warranty.
NEVER OPEN THE BATTERY PACK
The battery pack works at peak performance and in safe conditions with an ambient tempe‑
rature between ‑20°C and 40°C. Using the battery pack out of this temperature range may be
dangerous.
ATTENZIONE ATTENTION