JLG X23J Operator Manual - Manual (Page 98)

BOOM LIFT MODELS X23J
JLG
94 X23JR0620113
If one of the orange lights positioned on each outrigger should flash also when the outrig‑
ger is lifted from the ground, stop the machine immediately and call the after‑sales service
as this indicates the breakage of the corresponding outrigger micro switch.
If you are working with the machine stabilised on slippery surfaces (marble, porphyry, poli‑
shed cement, smooth humid surfaces etc.) control that the movements of the basket check
that the movements of the basket do not induce the track to move. In this case, it is necessary
to suspend the operations and restore the safe operational conditions established by the
manufacturer.
Make sure that the outriggers rest on horizontal land. DO NOT REST THE OUTRIG‑
GERS ON VERTICAL OR INCLINED SURFACES.
6.4.12 A
UTOMATIC STABILIZATION AND DESTABILIZATION
JLG aerial platform is equipped with an innovative self‑stabilization and self‑destabilization
system, which operates exploiting the electronic spirit level in the main control board.
For the self‑levelling procedure, all the cautions reported till now are valid.
Before starting the self‑stabilization make sure that the machine is on a slope less than the
total permitted limit for stabilization (see technical data of the machine) and verify that the
trajectory of the stabilizers is free of obstacles and impediments.
During the self‑stabilization and self‑destabilization procedure the outriggers, and conse‑
quently the machine, make automatic movements. Control always that no people, animals
or things are in the stabilization area.
• SELF‑STABILIZATION
Press and hold button 7 of the remote control .
ATTENZIONE
ATTENZIONE ATTENTION
ATTENTION