JLG X23J Operator Manual - Manual (Page 174)

9.2 E RRORS MENU
Indicates the congruent (OK) or not (FAULT) status of the sensors that have a double control.
The sensors are listed on two pages
The sensors are listed on different pages:
1 PREC
TURNS TO THE PREVIOUS PAGE
2 SUCC
GOES TO THE NEXT PAGE
9 ESCAPE
If the OK symbol appears at the side of the sensor it means that the two elements of the same
sensor send congruent information.
If the FAULT symbol appears at the side of the sensor it means that the two elements of the
same sensor send incongruent information.
The last page of the error menu describes the error code relating to the battery charger
system, inverter and battery pack. Errors are indicated by the “spanner” icon in position 7 on
the remote control display.
If there are operating problems with the machine and the “spanner” icon is shown on the
display, contact service department.
9.3 W ORKING HOURS MENU
Indicates the number of machine working hours.
9.4 S ET ‑ UP MENU
The items in this menu cannot normally be accessed.
9.5 J OYSTICK MENU
Displays the signal that each individual Joystick sends to the main board.
BOOM LIFT MODELS X23J
JLG
170 X23JR0620113