2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 100
100
of available relays and digital and analogue inputs. Notes can be added if available.
Click on
to change the terminal details.
Edit
Specify in the
in which group the selected terminal shall be visible
Terminal Groups
(i.e. which group shall be allowed to use this terminal). Click on
to add a group.
Add
Click on
to remove a group from the list.
Remove
You can also set communication for the RS–232 and RS–485/M–BUS ports even if the
terminal is connected and used for data transmission. Select the parameters using the
combo boxes and the changes will be effective when saved.
Create Terminal
Click on
next to the filter to create a new terminal.
Add terminal
Figure: Create Terminal
To add a terminal, enter the terminal name, serial number and password. The
parameters are limited and you will be checked during entering. No name or serial
number may be duplicated in the configuration. You will be notified of any duplication
in the configuration. Click on
to create a new terminal.
Create