Output circuits – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 23
Advertising
23
Figure: Jumper Setting–Basic Version
Figure: Jumper Setting–PRO version
Output Circuits
2N SmartCOM
®
is equipped with two relay outputs for turning on/off electrical
appliances (by an additional power switch, depending on their power input), or
signalling, control and so on. Remember to keep the parameters specified in the
Technical parameters at the end of this manual.
You can control the relay outputs with the AT commands from the CMD mode of the RS
232 interface, via a remote GPRS connection to the SIM card IP address, or using an
SMS message. Refer to
for AT command details and
for SMS
Subs. 4.2
S. 5
configuration details.
Advertising