2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 112)

112
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to know the terminal state. The reply is as follows:
Terminal state:
imei: 355915030753263
operator name: T–Mobile CZ (23001)
signal: 21
iccid: 8942001105088009270
imsi: 230015001013627
terminal serial number: 50–0369–0075
terminal firmware: 1.4.0.4.0
module firmware: L23_00gg.WISMO228 140711
module manufacturer: WAVECOM MODEM
module type: WISMO228
at^screl<ser_no>#<relay>?
Enter the command to know the state of the relay on the selected terminal.
at^screl<ser_no>#<relay>=<state>
Enter the command to set the relay contact position.
at^screl<ser_no>#<relay>=<state>,<state_after_term_restart>
Enter the command to set the relay contact position and define the contact
behaviour after the terminal restart.
at^scdin<ser_no>#<input>="get_value"
Enter the command to read the value from the digital input.
at^scadc<ser_no>#<input>="get_value"
Enter the command to read the value from the analogue input.
Port Settings
at^scport<ser_no>#<port>?
Enter the command to know the current port configuration. The reply is as
follows:
^SCPORT1, "BAUDRATE",115200
^SCPORT1, "DATA BITS",8
^SCPORT1, "PARITY",0
^SCPORT1, "STOP BITS",1
^SCPORT1, "FLOWCONTROL",0
at^scport<ser_no>#[port]=<BAR>,<DB>,<P>,<SB>,<FC>