Other commands – boot, state, service, others – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 47
47
SmartCOM state: Client authenticated
Leaving the test mode
OK
Caution
When you have sent the command to
, the data
2N SmartCOM
®
channel serving the peer on TCP port 10002 will be closed. It is
because this channel is used for GSM module communication during
command execution. When the command has been executed, the
original channel setup is restored and a new incoming connection is
awaited.
Other Commands – Boot, State, Service, Others
These commands are used for firmware upgrade and servicing of the GSM module.
at^scupg="http://star.2n.cz/~fejfar/SmartCOM_SC_v00-04.bin"
The command is used for firmware upgrade. It includes the address of the server
where it is located and the version to be downloaded.
at^screstart
The command is used for terminal restart.
at^scfres
This command makes the factory reset of the
unit connected.
2N SmartCOM
®
at^sc232lock=0–1
Enter the command to enable RS-232 authentication, i.e. password authorisation
for connection. 0 = disabled, 1 = enabled.
at^sc232lock?
Enter the command to display the current RS-232 lock setting state.
at^sc232lock=?
Enter the command to display the RS-232 lock setting options.
at+csq
Enter the command to display the signal intensity.
+CSQ: 99,99
at^scop?