Application use – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 70
70
Application Use
Tip
Not all tags are accessible to all device models.
General, RS-232, RS-485/M-Bus, Error buffer, Own AT
and
commands, FW upload, User defined functions
IP access
are accessible to all terminals.
and
are available to the
WM-Bus, RTC settings
Charger
SC PRO
and
terminals only.
SC PRO ETH
is accessible to the
terminals only.
Ethernet
SC PRO ETH
Having read configuration, go to the
tag of the
section.
General
Parameters
Figure: General Menu
Here you can set all parameters comfortably as you can with the AT commands
described in
, i.e. GSM commands plus automatic answer parameters. Push
t
S. 4
Save
o save the values. Push
to apply the changes immediately.
Save and restart
The Ethernet menu is only available to terminals equipped with an Ethernet port. Set
the primary data flow channel, LED signalling functions, obtaining IP address from the
DHCP server or static obtaining and DNS server use.