Sc ping – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 55
55
SC Ping
These commands are available in the
and
vers
2N SmartCOM
®
2N SmartCOM
®
PRO
ions only. Enter the commands to set periodical pinging to the set address in defined
intervals. Use SC Ping to ensure the correct function of NFG syntax in UDF or keep
firewall connection if the terminal is in the STANDALONE mode.
at^scping="host","8.8.8.8"
Enter the command to set the Host IP address to which the ICMP request shall be
sent.
at^scping="interval",5
Enter the interval in minutes. 0 means that periodical pings are deactivated.
at^scping="test"
Enter the 'test' command to test configuration before saving. The currently
changed value is always saved and thus no restart is needed during setting and
functionality check.
at^scping="save"
Enter the command to save the changes.
at^scping="restart"
Enter the command to restart the function.
at^scping="srestart"
Enter the command to save the changes and reset the ping parameters
immediately.
at^scping?
Enter the command to display the current interface values.
SCPING: "HOST","8.8.8.8"
SCPING: "INTERVAL",0
at^scping=?
Enter the command to display the interface setting options.
SCPING: "HOST","1-32"
SCPING: "INTERVAL",0-65534
SCPING: "TEST"
SCPING: "SAVE"
SCPING: "RESTART"
SCPING: "SRESTART"