2 factory default reset – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 136
Advertising
136
11.2 Factory Default Reset
2N SmartCOM
®
can be factory reset. To do so, loosen the screws and remove the
upper part of the case.
Figure: Factory Reset Jumper
Disconnect
from the power supply. Connect the jumper as shown in
2N SmartCOM
®
Fig. 11.1 (basic version on the left, PRO version on the right) and reconnect the power
supply. Now the Flash memory is deleted and the factory default values are reset for all
ports. Remember to remove the jumper to avoid deletion of the factory values upon
every start.
Advertising