2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 64)

64
2N TELEKOMUNIKACE a.s., www.2n.cz
®
ADD=<ip_addr> – add a selected IP address to the list end.
Caution
Enter the IP address in the numerical format only ranging from
0.0.0.0 to 255.255.255.255.
DEL=<ip_id> – delete the IP address on the selected list position.
Caution
Select in the ip_id parameter to delete all the IP addresses from the 0
list. The SMS will be as follows: . SC IPA PWD=password DEL=0
REP=<ip_addr_1>, <ip_addr_2>,…<ip_addr_5> – replace the existing
address list with a new one.
Example:
Suppose you want to know whether the IP access function is enabled. Send the
following SMS:
SC IPA PWD=<password>
The reply can, for example, look as follows:
AUTH=1 1:90.156.29.195 2:109.54.2.234
Now disable the IP access and delete all IP addresses from the list using the following
SMS:
SC IPA PWD= AUTHpassword=0 DEL=0
The following reply will come from the terminal:
AUTH=0 NO IP
Tip
NO IP means that there is no IP address in the address list.
Error Replies
Having noticed an error in the configuration SMS or command processing, 2N
®
will send you an error reply. SmartCOM If the terminal generated an error reply,
it means that the command was not executed!
Tip
2N SmartCOM
®
sends error replies until all the configuration SMS
parameters are OK and the command is executed.