2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 73)

73
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Display received messages in the section. The messages are read from Get message
the database starting with the oldest one. The Message count parameter displays the
count of received messages in the terminal and the amount of free space. When there
is no free space, the oldest record will be deleted to make space for a new message.
Push the
button to export all the messages stored in the terminal Export messages
into a PC file in order to make space for new messages.
The helps you display the error codes captured during the operation. If Error buffer
no error has occurred since the last clearing date, ^SCERR: NO ERROR will be
displayed. If an error occured, the error code will be displayed. Click on the Error code
table button to display the message decryption window.
Figure: Error Buffer
Use the tag to enter commands of your own for parameter Own AT commands
setting. The tag behaves like a terminal. Enter a string into the AT command field
corresponding to the supported commands listed in
. Click on to send Subs. 4.2 Send
the command to the connected unit and get the reply in the field 2N SmartCOM
®
below the command. A list of 20 last-applied commands is displayed to the right.