2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 54)

54
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to display the currently set Ethernet parameters.
^SCETH: "IP_METHOD","FIXED"
^SCETH: "LOCAL_IP","192.168.1.1"
^SCETH: "FIXED_IP","192.168.1.1"
^SCETH: "MASK","255.255.255.0"
^SCETH: "GATEWAY","192.168.1.254"
^SCETH: "DNS1","192.168.1.1"
^SCETH: "DNS2","0.0.0.0"
at^sceth=?
Enter the command to display the Ethernet setting options.
^SCETH: "IP_METHOD","FIXED"|"DHCP"
^SCETH: "LOCAL_IP"
^SCETH: "FIXED_IP","7-15"
^SCETH: "MASK","7-15"
^SCETH: "GATEWAY","7-15"
^SCETH: "DNS1","7-15"
^SCETH: "DNS2","7-15"
^SCETH: "SAVE"
^SCETH: "RESTART"
^SCETH: "SRESTART"
at^scchprim="GSM"
Enter the command to set the primary channel to be used for creating IP
connections.
GSM – connections will be created via GPRS.
ETH – connections will be created via Ethernet.
at^scchprim?
Enter the command to display the currently set primary channel.
at^scchled1="GSM"
Enter the command to set the LED function.
GSM – LED shows the state of GPRS connection.
ETH – LED shows the state of the Ethernet interface.
at^scchled1?
Enter the command to display the currently set LED function.