1 sc server, Installation – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 79
79
7.1 SC Server
2N SmartCOM
®
Server is an application necessary for the
Control
2N SmartCOM
®
Panel operation, providing communication between the
Control Panel
2N SmartCOM
®
and the terminal.
Caution
The
Server must be installed on a PC accessible from
2N SmartCOM
®
a public Internet. Or, a NAT rule has to be defined to provide access to
such PC. Otherwise, the terminals cannot be connected to the 2N
®
Server. You can select the ports to be forwarded to your
SmartCOM
LAN via the NAT during installation.
Installation
Once launched, the installation program will scan your PC. If it finds another 2N
®
Server version, it will ask you whether to uninstall. If you select No, the
SmartCOM
wizard will be terminated. If you select Yes, the current
Server
2N SmartCOM
®
version will be removed. Then you will be asked whether or not to remove the
configuration files. If you select No, the current configuration will be retained and the
application will only be updated.
Now the
Server Setup Wizard is launched. Follow the wizard
2N SmartCOM
®
instructions. Select the directory for the
Server to be installed. By
2N SmartCOM
®
default, C:\Program Files\
SC Server is
2N TELEKOMUNIKACE\2N SmartCOM\
®
®
used.
Also select the port for the application to communicate with the terminals and other 2N
Control Panel applications. Make sure that the port is accessible from the
SmartCOM
®
Internet (see above) and properly configured in all terminals and applications. Http
accessibility is necessary as the selected port provides a listing of LOG files and can be
used for firmware downloading to terminals. Firmware is downloaded whenever
upgrade is initiated by the
Control Panel or the address is entered
2N SmartCOM
®
into the terminal.
Here you can also set the port for the AT API; refer to S. 8 for details. Now the wizard
is ready to install the
Server. It displays the list of settings. Check the
2N SmartCOM
®
set parameters carefully as the values cannot be changed without reinstallation when
the installation has been completed! If you find an error, push the
button to
Back
return to the respective window. If all the settings are OK, push
to continue.
Install
The wizard now installs the
Server.
Server
2N SmartCOM
®
The 2N SmartCOM
®
service is launched automatically after installation. If the automatic launch fails for any
reason, launch the service manually. Now the
Server is ready for
2N SmartCOM
®
use.