Power supply – 2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 17
17
1.
2.
Figure: SIM Card Installation
Insert the SIM card in the holder.
Push the card in until it clicks into position.
Caution
Make sure that the GSM provider's SIM card is intended for the GSM
network supported by your
version and that
2N SmartCOM
®
GPRS–based data transmission is activated.
Make sure that the SIM card does not request the PIN or that the PIN
is identical with that set in the
configuration.
2N SmartCOM
®
Remember to set the relevant SIM and provider's services (call
forwarding, call barring, preferred networks, SMS centre, etc.) on your
mobile phone (
) before inserting the SIM card in
2N MeterModem
®
2N SmartCOM.
®
Power Supply
2N SmartCOM
®
is DC supplied from a 12V/0.5A power adapter. Make sure that the
voltage value and polarity comply with the data specified at the
powe
2N SmartCOM
®
r connector before connecting your
to an adapter other than that
2N SmartCOM
®
included in the delivery.
is DC supplied in the range of 5–50V. Make sure that the
2N SmartCOM PRO
®
voltage value and polarity comply with the data specified at the
powe
2N SmartCOM
®
r connector before connecting your
to an adapter other than that
2N SmartCOM
®
included in the delivery. Connect the supply voltage to the 4–pin connector next to the
RS232 connector. You can also connect there a gel–lead–acid accumulator as a power
supply backup. The supply voltage is also present on the 10–pin input circuit terminal
block on the opposite side of the device. These contacts can be used as auxiliary, e.g.
for connecting supply voltage to relays.