2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 119)

119
2N TELEKOMUNIKACE a.s., www.2n.cz
®
9.2 UDF Condition Setting
This subsection provides all the AT commands and parameters that can be used for
setting of UDF conditions. The basic commands are described first and then their parts
are explained.
Basic AT Commands
These are the basic commands for the UDF. 2N SmartCOM
®
AT^SCUDF="ADD"," "
The "ADD" command adds a condition to the list of conditions. The command
section marked as the code is the condition itself. The terminal replies OK after
saving.
Caution
When the OK message is received, the condition will be listed and
available for work. Therefore, mind that an SMS or TCP message can
be sent or the relay can be activated immediately.
AT^SCUDF="CLEAR"
Enter the command to clear all conditions from the terminal memory.
AT^SCUDF="REMOVE",
Enter the command to clear the condition with the selected ID.
AT^SCUDF?
Enter the command to list all the conditions saved.
AT^SCUDF=?
Enter the command to display the setting options.
^SCUDF: "ADD","0–100" ^SCUDF: "REMOVE",1–10 ^SCUDF: "CLEAR"
Supported Syntaxes
The condition parameters can be entered in variable ways. For universality, each of the
parameters can be a digit, i.e. an analogue input value or a binary input (0–1). Set a
specified syntax to select one of the available setting options.
The UDF can work with the following parameters: