2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 91
91
- disconnection from the virtual port is in progress.
Disconnecting
- the terminal is off-line, i.e. has been disconnected
Terminal Disconnected
from the SC server.
- the terminal has been disconnected by another
Disconnect by other user
user. This means that the other user has interconnected its virtual port with this
terminal.
- an error occurrred during connection or disconnection.
Error
The
and
fields display the amount of data transmitted in
Incoming
Outgoing Data
the given direction and are for information only. Check off
to
Permanent connection
enable automatic terminal connection to the virtual port upon the application start.
Press
to interconnect the terminal with the virtual port. If one and the same port
Start
is used by multiple terminals, the other users will not be able to press
until the
Start
first connection has been finished. Refer to the note below. Push
to terminate
Stop
communication.
Note
Although there may be multiple terminals assigned to a virtual port,
one terminal can only be assigned to the port within one connection.
In case another user is connected to the terminal, the
button has an orange
Start
background colour. You can push the button to disconnect the original user and
connect the terminal with your virtual port.
Use the cross to remove the selected row from the table, thus cancelling
interconnection between the virtual port of the application and the physical port of the
terminal easily.