2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 105
105
Update Firmware
Figure:
Scheduled terminal update
Click on
to open a new window for you to schedule the upgrading date and
Update
time for the selected terminals. Push Yes to execute update immediately. As the
current system time is running on the server, the updating procedure will start
immediately. To execute update later, set the required date and time. The update will
start automatically on the selected day and at the selected time.
Note
There is a server limitation as to the count of terminals for updating.
If you want to update more terminals than 10 at the same time, the
first 10 terminals will start updating at the specified time, the next 10
terminals will start updating in one minute and so on until all the
selected terminals have been updated. The purpose of this limitation
is to protect the server stability and keep the required rate.